A no-load pot has several cool uses in guitar wiring. For one, it can replace a standard tone pot. Typical tone controls still have an effect, even when turned all the way up, but a no-load pot will essentially take the tone control out of the circuit, when turned up to 10. You can also use one as a blend pot to blend pickups into each other. You can buy a no-load pot, or you can make one out of a regular pot. Here's how I turned a standard CTS pot into a no-load pot to use as a blender. Tools you need: Tiny flathead screwdriver, or something similar Needle-nose pliers Xacto knife Steps: Start taking apart the pot by using the screwdriver to pry up the four tabs circled in red in the picture below. Then use the needle-nose pliers to bend them back. Don't bend them too far, or they might break - just bend them enough so that they're about straight. It should look something like this: Next, take the threaded shaft off. Then take off...